Shindaiwa AH230 Bedienungsanleitung

SHINDAIWA OWNER’S/OPERATOR’S MANUALMinimize the risk of injury to yourself and others! Read this manual and familiarize yourself with the contents.

101. Clean outer tube so the labels will adhere properly. 2. Peel the backing o the multiple warning label and attach below similar label on lower

11Installing and Adjusting the Bar and ChainInstalling The Chain WARNING!Never attempt to install, replace, or adjust the chain with the engine runnin

12WARNING!Never attempt to install, replace, or adjust the chain with the engine running. WARNING!The saw chain is very sharp. Wear gloves to protect

13Adjust the pump as follows:1. Stop the engine and make sure the stop switch is in the OFF position.2. Place the unit on its side with the oil rese

14Flush-cutting Thick Branches:If branch diameter is more than 10 cm, rst perform undercut (3) and cross-cut at a distance (A) of about 25 cm from th

15WARNING!Before performing any maintenance, repair, or cleaning work on the unit, make sure the engine and cutting attachment are completely stopped.

16Sharpening the Chain When the cutting edges of the blade become dull, they can be re-sharpened with a few strokes of a le. In order to keep the

17ADDITIONAL PROBLEMSSymptomPossible CauseRemedyTroubleshooting GuideEngine idle too high.Broken clutch spring or worn clutch spring boss.Warped or da

18NOTES

19NOTES

2NOTE:A statement preceded by the word “NOTE” contains information that is handy to know and may make your job easier.IntroductionThe Shindaiwa Pole P

ECHO Incorporated.400 Oakwood RoadLake Zurich, IL 60047-1564 U.S.A.Telephone: 1-877-986-7783Fax: 1-847-540-8416www.shindaiwa.com Yamabiko Corporation

3CAUTION! Always maintain the Pole Pruner Tool according to this owner’s manual and follow the recommended scheduled maintenance.  Never modify or

4Always operate with both hands rmly gripping the machine.Wear nonslip heavy-duty work gloves to improve your grip on the pole pruner handle. Wear s

5Safety LabelsIMPORTANT!Safety and Information Labels: Make sure all safety and information labels are undamaged, readable and up to date. Immediately

61. Place the T230 or PB230 on a clean at surface, in an upright position.2. Remove the cylinder cover as instructed in your unit owner's manu

7 To avoid serious injury, grip the outer tube securely with one hand and cut away from that hand when slitting the rubber throttle grip.WARNING!1.

8Reconnecting the Throttle Cable, Switch WiresConnect The Throttle Cable.1. Loop the ribbed cable assembly to the top left side of the engine. Conrm

91/4”F3. When 1/4-inch of free play is achieved, securely tighten the two 10mm throttle cable nuts. When the throttle cable is correctly adjusted, an