Shindaiwa C220 Betreibershandbuch PDF herunterladen (Seite 7)

7

Handle T220

1. Put 4 square nuts in the frame of

barrier.

2. Fit the handle and barrier over the

outer tube and tighten four bolts.

NOTE:

Tighten four bolts in diagonal fashion for

protection of the handle.

NOTE:

Adjust the handle to the best position for

operator comfort.

26005

Outer Tube

Socket-head

Cap Screws

Handle

Barrier Bar

Throttle

Assembly

Nuts

Handle Positioning Label

Assembly of the Handle

Assembly of the Handle

27009B

Handlebar

Spacer

Spacer

Socket Head

Cap Screws

Lower Cap

Handle Positioning Label

Engine

Handlebar C220

1. Position the handle over the handle

label on the outer tube. Make sure the

throttle lever is on the right-hand side of

the outer tube.

2. Attach the handle mounting bracket

using the two socket-head cap screws,

washers, and lock washers. At this time,

ONLY ﬁnger tighten the screws.

3. Locate the handle about 5 inches ahead

of the shoulder strap hanger or at the

best position for operator comfort.

IMPORTANT!

Regardless of handlebar location, the

aluminum collar must remain in position

between the handlebar and the outer

tube. If the collar is omitted or is improp-

erly installed, the handlebar bracket can

not be properly secured.

4. Using the hex wrench, securely tighten

the two handlebar cap screws.

5. Route the ribbed throttle cable tube

along the handlebar and outer tube.

Install the protector sleeve on the outer

tube.

1 2 3 4 5 6 7 8 9 10 11 12 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare