Shindaiwa C220 Betreibershandbuch PDF herunterladen (Seite 10)

10

1031

C220

1. Turn the brushcutter over so that the

gearcase output shaft faces UP.

2. Remove the safety clip and slide holder

B onto the output shaft.

3. Rotate the tool holder and shaft until the

notch in the holder aligns with the notch

on the gearcase ﬂange. Use the long

end of the hex wrench to lock the output

shaft in position.

IMPORTANT!

The trimmer head has a left-hand thread.

Turn the trimmer head counter-clockwise

to install.

1. Make sure the switch is turned off and

the engine is stopped.

2. Turn the unit over so the shaft from the

gearcase faces up.

3. Install the collar to the gear-shaft and

place the holder onto the gear-shaft.

NOTE:

The collar and the holder are in the tool bag.

4. Rotate the holder until the hole in the

holder aligns with the notch on the

gearcase ﬂange. Using the hex wrench,

lock the gearcase as shown.

5. While holding the holder with the hex

wrench, thread the trimmer head onto

the gear-shaft and install securely using

hand pressure.

a. F220

Turn clockwise to install.

Installing a Trimmer Head

b. T220/C220

Turn counter clockwise to install.

6. Remove the hex wrench.

4. While holding the hex wrench, thread

the trimmer head onto the output shaft,

turning counter-clockwise.

5. Using hand pressure only, tighten the

trimmer head ﬁrmly on the gear-shaft.

6. Remove the hex wrench.

F220/T220

Collar

Gearshaft

Holder

Notch

Arbor Bolt

Bolt Guard

Output

Shaft

Holder B

F220 C220/T220

Hex Wrench

Holder B

Output Shaft

Remove

Safety Clip

Holder A

Thread on the

trimmer head

Holder B

Holder A

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare