Shindaiwa 78703 Betreibershandbuch PDF herunterladen (Seite 6)

WARNING!

Hedge Clipper blades are very sharp. Touching them may lead to severe

personal injury. Avoid touching blades whenever possible, and always wear

gloves to protect hands.

Assembly

NOTE:

For normal cutting, Shindaiwa strongly recommends the blade stiffener be installed.

In extreme conditions, such as commercial cutting, or when cutting thick and/or dense

branches, efciency may be increased by trimming without the blade stiffener.

Tools required: (2) 8 mm sockets and extensions

M23004

1. Place the Multipurpose Tool Carrier (A) and the Tool Assembly (B) on a clean,

at surface so that both assemblies t end to end. The powerhead assembly

should be facing up, and the tool assembly should be positioned with the lock-

ing hole in the tube (C) end facing up.

CAUTION!

Keep the open ends of the tubes clean and free of Debris!

2. Slip off the protective cover from the end of the tool, and loosen the coupler

screw knob (D).

3. Insert the tool assembly into the coupler (E), with the tool decal facing up, until

the line of the decal is ush with the end of the coupler. Twist the tool back and

forth until you are sure it snaps in place by the coupler latch (F).

4. When the two tube halves are locked together, press down on the spring-load-

ed latch protector (G) and tighten the coupler screw knob.

Disassembling The Pole Sections

1. Place the Multipurpose Tool Carrier and the Tool Assembly on a clean, at sur-

face, loosen the coupler screw knob (D). The spring-loaded coupler protector

(G) should pop up.

2. Press down on the latch (F) with your nger or thumb. This releases the cou-

pler latch.

3. Pull the tool assembly (B) out of the coupler (E).

Installing a Tool Attachment

M23005

M23006

Blade Stiffener Removal/Install

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Shindaiwa 78703 Betreibershandbuch Seite 6