Shindaiwa T272X Betreibershandbuch PDF herunterladen (Seite 16)

16

IMPORTANT!

All stored fuels should be stabilized with a

fuel stabilizer such as STA-BIL™ , if

oil with fuel stabilizer is not used.

Long Term Storage

Whenever the unit will not be used for 30

days or longer, use the following proce

-

dures to prepare it for storage:

 Clean external parts thoroughly.

 Drain all the fuel from the fuel tank.

To remove the remaining fuel from the

fuel lines and carburetor and with the fuel

drained from the fuel tank.

1. Prime the primer bulb until no more fuel

is passing through.

2. Start and run the engine until it stops

running.

3. Repeat steps 1 and 2 until the engine will

no longer start.

 Remove the spark plug and pour about

1/4 ounce of 2-cycle mixing oil into the

cylinder through the spark plug hole.

Slowly pull the recoil starter 2 or 3 times

so oil will evenly coat the interior of the

engine. Reinstall the spark plug.

 Before storing the unit, repair or replace

any worn or damaged parts.

 Remove the air cleaner element from the

carburetor and clean it thoroughly with

soap and water. Let dry before reinstall

-

ing the element.

 Store the unit in a clean, dust-free area.

CAUTION!

Gasoline stored in the carburetor for

extended periods can cause hard start-

ing and could also lead to increased

service and maintenance costs.

When the blade’s cutting edges become

slightly dull, they can be resharpened with

a few strokes of a ﬁle.

In order to keep the blade in balance, all

cutting edges must be sharpened equally.

Round

File

Filing Direction

Blade Sharpening

Shindaiwa Tornado™ Blade

To sharpen the cutters on a Shindaiwa Tor-

nado Blade, use a 7/32-inch round ﬁle. File

the leading edge of each tooth to a razor

edge. The top plate of each tooth should

angle back 30°.

WARNING!

Sharpen the cutting teeth only. DO

NOT alter the contour of the blade in

any way.

Multiple-tooth Circular Blade

Use a round ﬁle to maintain a radius of 0.04

to 0.06” (1 to 1.5 mm) at the base of each

tooth. Cutting edges must be offset equally

on each side.

Round

File

Filing Direction

30°

Figure 32

Figure 33

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare