Shindaiwa P231 Betreibershandbuch PDF herunterladen (Seite 10)

Lower

Tube

Handle

Grip

Ignition

Switch

Coupler

Bar and

Chain

Upper

Tube

Throttle Trigger

Product Description

IMPORTANT!

The terms “left”, “left-hand”, and “LH”;

“right”, “right-hand”, and “RH”; “front”

and “rear” refer to directions as

viewed by the operator during normal

operation.

Prior To Assembly

Using Figure 4 as a guide, familiar-

ize yourself with the Shindaiwa P231

pole pruner and its various compo-

nents. Understanding your unit helps

ensure top performance, longer

service life, and safer operation.

Before assembling, make sure you

have all the components required for a

complete unit:

■ Powerhead assembly

■ Lower tube assembly

■ Upper tube/saw assembly, chain

and guide bar

■ Kit with this manual and tool kit for

routine maintenance.

■ Scabbard.

Carefully inspect all components for

damage.

P231_3

Fuel Tank

Air Filter

Assembly

Recoil

Starter

Top Engine

Cover Screw

Powerhead Assembly

Spark

Plug

P231_5

Gearcase

Bar Oil Reservoir

Cutting Head

Assembly

Guide Bar

and Chain

Oil Filler

Cap

10

Figure 4

WARNING!

Do not make unauthorized

modifications or alterations to your

pruner or its components.

DESCRIPTION

27

Long Term Storage

Whenever the unit will not be used for

30 days or longer, use the following

procedures to prepare it for storage:

■ Clean external parts thoroughly

and apply a light coating of oil to all

metal surfaces.

■ Drain all the fuel from the fuel tank.

To remove the remaining fuel from

the fuel lines and carburetor and with

the fuel drained from the fuel tank.

1. Prime the primer bulb until no

more fuel is passing through.

2. Start and run the engine until stops

running.

3. Repeat steps 1 and 2 until the

engine will no longer start.

■ Remove the spark plug and pour

about 1/4 ounce of 2-cycle mixing

oil into the cylinder through the

spark plug hole. Slowly pull the

recoil starter 2 or 3 times so oil will

evenly coat the interior of the

engine. Reinstall the spark plug.

■ Before storing the unit, repair or

replace any worn or damaged parts.

■ Remove the air cleaner element

from the carburetor and clean it

thoroughly with soap and water.

Let dry and reassemble the

element.

■ Store the unit in a clean, dust-free

area.

CAUTION!

Gasoline stored in the carburetor

for extended periods can cause

hard starting, and could also lead

to increased service and mainte-

nance costs.

IMPORTANT!

All stored fuels should be stabilized

with a fuel stabilizer such as

STA-BIL™ , if oil with fuel

stabilizer is not used.

MAINTENANCE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Kommentare zu diesen Handbüchern

Keine Kommentare